| Markham, Ontario | SVD48600P | F5 / F3 | Auxilary fan starts up and then F3 or F5 code comes up and stove turns off. Screen at times goes blank. This usually happens after 1/2 hour of the stove being on. Stove will not reach 350 | Repaired |
| Honesdale, Pennsylvania | SVD48600P | N/A | UNIT JUST GOES BLANK
COMES BACK ON, SOMETIMES QUICKLY
SOMETIMES AFTER AN HOUR | Repaired |
| Troy, North Carolina | SVD48600P | F3 | F3 code oven doesn't reach set temp | Awaiting receipt of timer |
| Harborside, Maine | Svd48600p | N/A | Only function is bake at 350 | Awaiting receipt of timer |
| Lac Supérieur, Quebec | SVD48600PC | N/A | Oven stop and screen turn off also after 5 min. We reset and still shut off | Awaiting receipt of timer |
| Hopkinton, New Hampshire | SVD48600P | F-1 | F-1 code will not stop beeping | Awaiting receipt of timer |
| Davidson, North Carolina | SVD-48600P | N/A | Tabs are broke and buttons don't work | Awaiting receipt of timer |
| Marshfield, Massachusetts | SVD 48600P | N/A | we had a technician come in and look at our oven.
We were told we would need a new clock assembly/oven controller - # 5700M662-60
The Serial #: 13397768uk
Other information written on slip:
Electronic control NLA03112
Kitchen Aid Duel Down Draft KSDg950ESS
Jenn Air Dual fuel Down Draft IDS1750FS | Awaiting receipt of timer |
| Mountain Brook, Alabama | | N/A | "up" key is inoperative | Awaiting receipt of timer |
| St Helena, California | SVD 48600P | none | when you push the button to increase the oven temperature, the temperature goes down. Can't get the temp above 325 degrees which is where it is when you press oven on | Awaiting receipt of timer |
| Kingston, Ontario | svd48600pc | Oven not going above | Gas cook top working fine.
Oven works only to 350. Will not heave above that.
Will take a new or reconditioned replacement. Thank you. | Repaired |
| Olympia, Washington | Svd48600p | No code - won't heat | Everything works except - the oven (bake or broil). Won't heat. Just stopped working. This happened before and I had to replace the board. When I turn the oven on I hear a click and then a second click, after a few seconds it does this again. Dave 360-480-9471 | Repaired |
| MIDLOTHIAN, Texas | SVD48600P | Lack | Cant adjust heat higher than 350. Goes down but not up. Up button doesnt appear to work | Awaiting receipt of timer |
| Fayetteville, Georgia | SVD48600P | F3 | Front panel cover has hole and up button might need repair. F3 code following temperature climbing randomly. | Beyond Repair |
| Trochu, Alberta | SVD48600PC | F3 | Oven heats up to temperature, then in about 10 minutes it gives the F3 Error. The very first time was a F5 Error code, then consistently was F3 after many attempts. Did the usuals, turned off the breaker, restarted, still code F3. Note: we put a brand new sensor in and still get the F3 Error code. | Repaired |
| Davidson, North Carolina | SVD48600P | N/A | Up arrow button to increase oven temperature does not work. | Awaiting receipt of timer |
| Delaware, Ontario | S VD 48600PC | no code, just shuts | One day the clock/control panel just shut off. At that time, if we waited a while it would come back on flashing. We would reset everything and all would be good for a short period. Then the same thing would happen. Only as time went on, it didn't come back on. Now it just flashes the time and when we try to turn things on, it just shuts off again. So it can't be used at all now. | Repaired |
| Harrisburg, Pennsylvania | SVD48600P | F7 | display went blank for a few minutes. Now displays F7 code. | Awaiting receipt of timer |
| The Colony, Texas | SVD48600P | No code, there is no | No display on time, all buttons unresponsive. | Beyond Repair |
| Mississauga, Ontario | SVD48600PC | N/A | There is an up and down arrows which adjusts both timer and oven temp. Up arrow has bit the dust- gets used the most. Problem is not interrmittant | Repaired |
