| Bloomville, Ohio | Crg9700aal | F5 | Oven will not light | Awaiting receipt of timer |
| Great Falls, Montana | crg9700aaw | f7 | Oven doesn't come to temp. When the timer indicates 400F, a digital BBQ sensor shows 270F
The temp probe resistance is 1080 ohms, which some claim is good.
I tested the bake and broiler igniters at 3.2-3.6 amps, which some claim is good.
I swapped the broiler and bake igniters. Same results.
I've ordered a new igniter and temp sensor, just 'cause.
I inspected the timer for burns, bulging caps etc, and reseated all the connectors. No change. The timer is multi-board. Ididn't remove it to inspect for other damage.
I tried to set the timer thermostat calibration, and it reluctantly let me in to do so. Now when I try to access the calibration it does nothing for about 10 sec, then shuts off with an F7 code. | Awaiting receipt of timer |
| Calgary, Alberta | crg9700aaw | N/A | Oven does not reach temperature, it is reliably low (~300 or less when set at 550)... Changed the temperature sensor, no change... confirmed the sensor is ~1100ohms at room temperature | Repaired |
| Rochester, New York | | N/A | oven will not light | Repaired |
| Belford, New Jersey | CRG9700AAL | No code | After setting oven temperature oven does not turn on, temperature on display stays st set temperature, does not go down to actual temp. Broiler also does not turn on. | Repaired |
| COCHRANE, Alberta | CRG9700AAL | no codes available | My current timer/control is malfunctioning. My oven will not maintain the selected temperature. It will only heat to 200 degrees F. or wide open.
Both temperature sensor and igniter have been replaced. | Repaired |
| Oakville, Ontario | CRG9700AAW | F1 | Getting F1 code and constant beep | Awaiting receipt of timer |
| fair lawn, New Jersey | CRG9700AAL | F-1 | F-1 error displays, once reset may come back in 10 minutes or 3 days. | Awaiting receipt of timer |
| Calgary, Alberta | CRG9600 | F1 | Touch pad if faulty on some functions.
Can you REPAIR or REPLACE? | Awaiting receipt of timer |
| Burnaby, British Columbia | CRG9700AAW | N/A | During Bake, oven will only heat up to 150F. The gas shuts off too early it would seem, you can hear the bake relay click when the gas turns off. Sometimes when turning on the Bake/oven the bake relay does not click on as rapidly as the broil relay would.
The temp sensor and igniter was replaced with new components, but they did not solve the problem. | Repaired |
| Overland Park, Kansas | CRG9700AAL | F1 | The range was unused for approximately 4 years. After placing it in service a power outage occurred. The timer began to beep and display F1. Unplugging the range did not solve the issue. The error does not occur when the oven is active! | Awaiting receipt of timer |
| Overland Park, Kansas | CRG9700AAL | F1 | THE RANGE WAS UNUSED FOR APPROXIMATELY 4 YEARS. AFTER PLACING IT IN SERVICE, A POWER OUTAGE OCCURRED. AFTER THE POWER OUTAGE THE TIMER BEGAN TO BEEP AND DISPLAY F1. UNPLUGGING THE RANGE DID NOT SOLVE THE ISSUE. THE ERROR DOES NOT OCCUR WHEN THE OVEN IS ACTIVE. | Awaiting receipt of timer |
| Wyoming, Michigan | CRG9600AAW | N/A | Gas valve opens and ignites but oven does not heat up close to desired temp. It take a long time to bake anything. | Repaired |
| SOUTH BEND, Indiana | crg9700aal | N/A | relay panel burned out | Replaced with reconditioned timer |
| Sharpsville, Indiana | CRG9700AAL | N/A | Oven ignites and stays on for only 20 seconds and shuts off never allowing temp to get above 100 degrees eventhough it is set at 400 degrees. oven ignitor and temp sensor was replaced with no change in operation. | Awaiting receipt of timer |
| yonkers, New York | crg9800AAW | None | When the oven temperature is selected the" BAKE" light goes on and then the "ON" light goes on but the oven does not heat up.
I called Sears and asked them to check the oven igniter (Maytag"s suggestion) The repairman tested the igniter as well as the wire from the timer while the BAKE and ON lights were on. The oven did not go on. The repairman then tested the wire from the timer and found the wire did not have any power ( I am assuming that the wire from the timer to the igniter is working properly as well as the igniter). | Awaiting receipt of timer |
| Wisconsin Rapids, Wisconsin | CRG9700AAL | F5 | When turning oven on and setting the temperature it flashes F5 and beeps after a few moments. There is also some question as to whether or no the oven is reaching the actual temperature we set it to although that has not been verified. | Awaiting receipt of timer |
| Prescott Valley, Arizona | CRG9700AAW | ? | Oven comes on, heats to about 125 degrees and shuts off even though it has been preset to 350 or whatever. Replaced oven temp sensor first. | Repaired |
| Wisconsin Rapids, Wisconsin | CRG9700AAL | F5 | When turning oven on and setting the temperature it flashes F5 and beeps after a few moments. There is also some question as to whether or no the oven is reaching the actual temperature we set it to although that has not been verified. | Awaiting receipt of timer |
| courtland, Ontario | crg9600aaw | N/A | ours blew up need a new one to replace the original one | Awaiting receipt of timer |
