WD21X10150 General Electric Dishwasher Timer Repair |
Failure codes, problems, and resolutions for General Electric timer model # WD21X10150 |
![General Electric (GE) ERCs and General Electric (GE) stove clocks and timers]() |
Manufacturer : |
General Electric |
| Part Number : |
WD21X10150 |
| Appliance Type : |
Dishwasher |
| Color : |
|
| Description : |
Control assembly |
|
Do you have a failed General Electric WD21X10150 timer?
Click here:
We can repair or replace your faulty WD21X10150 timer. |
![Request Appliance Timer Service]() |
Recent Service Requests for General Electric Part Number WD21X10150| City | Model Number | Failure Code | Problem Description | Resolution |
|---|
| Zebulon, North Carolina | GSD2800G03 | N/A | Pump always starts after several hours of off, but Interrupting cycle by opening door, causes pump motor not to restart.This occurs with false blocked arm and when adding detergent tabs. A firm slap on the display approximately where the pump motor relay is located usually restarts it and it finishes. False blocked arm trips occur before the wash cycle only. | Repaired | | Laguna Niguel, California | GSD3000W13 | N/A | Dishwasher display controls do not work. Repairman said needs main computer and no longer made. | Awaiting receipt of timer | | New York, New York | | N/A | PART FAILURE | Awaiting receipt of timer | | van nuys, California | gsd3000w16 | f4,f8,some times f13 | we replaced circulation motor pump,soap dispenser is working properly, | Awaiting receipt of timer | | Fairfield, Connecticut | | See "Problem Symptom | Problem: No 120VAC power sent from timer to pump/motor.
1) Timer display lights, responds to touchpad just fine.
2) Solenoids/sensors apprear to deploy correctly during cycle.
3) Pump/motor does not run -- no 120VAC power detected at motor leads.
4) Pump/motor runs fine when motor leads hooked up to independent 120VAC power source.
5) Full continuity from each timer motor connector pin (#1 and #10) to corresponding motor lead, through all wiring and junction blocks. | Awaiting receipt of timer | | Fairfield, Connecticut | | No power to motor le | Terminal #1 on the timer junction block is burned out -- solder no longer connects pin to board. This pin powers the motor, which appears to work fine, and to have proper resistance. All other timer functions appear to work. Looks repairable, but would rather have you ship me a reconditioned, warranted timer from inventory ASAP, for the extra $25. | Awaiting receipt of timer |
|
